hey guys n gals. over the past couple of years I have ran into this problem a handful of times I was thinking about emailing the Nartron Company but figured I'd post on the motorpool first. Has anyone noticed on the newer PCBs that the tang to line up the cannon plug inside the engine compartment is 180 degrees off from the older versions? This only concerns me because on a couple of jobs I have replaced the glow plugs and not the PCB and controller and the system did exactly what it is supposed to do and started just perfect in cold weather. However, the motor SGT at the time ordered the newer PCB with controller (matched set) and insisted that I install them as well. I noticed the cannon plug tang was 180 degrees off from the original one but went through with it anyway and on the first try destroyed every glow plug. Any thoughts?
↧